Zilog ZUSBOPTS Uživatelský manuál stáhnout pdf (Strana 91)

100

101

UM017105-0511 Menu Bar

Zilog Developer Studio II – ZNEO™

User Manual

visual indication to remind you that some of your project settings might not be fully taking

effect on later builds. If you need to create a complex linker command file, contact Zilog

Technical Support for assistance. See Zilog Technical Support

on page vii.

If you have selected the

Additional Directives checkbox, your manually inserted direc-

tives are not erased when you build your project. They are retained and re-inserted into the

same location in each newly created linker command file every time you build your proj-

ect.

In earlier releases of ZDS II, it was necessary to manually insert a number of directives if

you had a C project and did not select the Standard C Start-up Module. This is no longer

necessary. The directives required to support a C start-up module are now always added to

the linker command file. The only time these directives are not added is if the project is an

Assembly Only project.

Use Existing. Observe the following procedure if you do not want a new linker command

file to be generated when you build your project:

1. Select the

Use Existing button.

2. Click the

Browse button ( ). The Select Linker Command File dialog box is dis-

played; see Figure 55.

3. Use the

Look In drop-down menu to navigate to the linker command file that you

want to use.

Figure 55. Select Linker Command File Dialog Box

Note:

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 519 520

Komentáře k této Příručce

Žádné komentáře

Zilog ZUSBOPTS Uživatelský manuál Strana 91

Komentáře k této Příručce

Související produkty a manuály pro Senzory Zilog ZUSBOPTS