Zilog ZMOT0BHH Uživatelský manuál stáhnout pdf (Strana 22)

UM023902-1013 18

ZMOTION

20-Pin Detection and Control Development Kit

User Manual

7. An information notice may appear, indicating that the silicon is not the latest version.

This occurrence is normal and is not an issue. Click

OK to continue. You should see a

message in the Debug Output Window indicating that the load was successful, as

shown in Figure 15.

8. Click the

Go icon to start the application running. The Red LED (LED3) will be ON

initially until the pyroelectric sensor stabilizes – a period that can take up to 30 seconds.

After it has stabilized, (LED3) turns OFF, to turn ON only when motion is detected.

9. To test this procedure, wave your hand over the lens and notice (LED3) turning ON for

approximately 1 second.

Figure 14. The Location of the Rest and Go Icons

Figure 15. ZDS II’s Debug Output Window for the ZMOTION_Serial_Config Project

The Reset icon The Go icon

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 33 34

Žádné komentáře

Zilog ZMOT0BHH Uživatelský manuál Strana 22