Zilog Z8F0130 Uživatelský manuál stáhnout pdf (Strana 98)

Using the Integrated Development Environment UM013037-1212

Zilog Developer Studio II – Z8 Encore!

User Manual

When the target label is external to the assembly file, the assembler always assumes

that the target address is out of range.

It is usually preferable to allow the assembler to make these replacements because if the

target of the jump is out of range, the assembler would otherwise not be able to generate

correct code for the jump. However, if you are very concerned about monitoring the code

size of your assembled application, you can deselect the

Jump Optimization checkbox.

You will then get an error message (from the assembler if the target label is in the same

assembly file or from the linker if it is not) every time the assembler is unable to reach the

target label with a relative jump. This might give you an opportunity to try to tune your

code for greater efficiency.

The default is checked.

C: Code Generation Page

For Assembly Only projects, the Code Generation page is not available.

The options in the

Code Generation page are described in this section.

Note:

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 213 214

Žádné komentáře

Zilog Z8F0130 Uživatelský manuál Strana 98